Varitube VT 510-V2 Connector

$3.95$74.95

Varitube VT 510-V2 Connector

$3.95$74.95

Varitube VT 510-V2 Connector — Self Adjusting Center Pin

Black — 22mm — Air Channels

The Varitube VT510 V2 is here!  A Bullet Proof Connector:
– NO Need to disassemble for soldering
– NO Threaded insulators to strip
– NO max wire gauge restrictions
– Solder before or after installation

 

 

SKU: N/A Category:

Varitube VT 510-V2 Connector — Self Adjusting Center Pin

Black — 22mm — Air Channels

The Varitube VT510 V2 is here!  A Bullet Proof Connector:
– NO Need to disassemble for soldering
– NO Threaded insulators to strip
– NO max wire gauge restrictions
– Solder before or after installation
Only 11.5mm long – note you need an additional 2.5mm-3mm to allow movement within the installation
Note –  Properly adjust the T-Nut by loosening or tightening it such that the small pin is flush with the bottom of the slot in the T-Nut on the bottom of the connector … This allows the top insulator to properly adjust and seat with the Atomizer providing smooth operation.  Pre-loading the spring with an over tightened T-Nut may result in ‘ratchety’ movement while installing an atomizer … Adjust the T-Nut prior to soldering!
Ultra low profile shoulder, self-adjusting spring loaded center pin, brass backer nut for solid and secure installation.
Made of Stainless, Brass, & High Temp insulating material this connector is perfect for box mods and the discerning modder!
  • The spring carries no electrical load!
  • 22mm with Air Channels
  • 22mm Smooth Top
  • Only 1mm thick landing pad
  • Made of Stainless with High Temp Insulator, and brass – rated for 450F degrees continuous service
  • Assembled connector length – 11.5mm – extends to about 14mm with atomizer installed
  • Body threading – M10x0.5 – 10mm diameter … about 3/8″
  • Ring Terminal for ground connection included
  • Does NOT need to be disassembled for soldering!!!  Huge productivity gain!  Can be soldered after install as well if desired.  Only adjustment needed is to make sure the bottom T-Nut is not over tightened prior to soldering.
  • Properly adjust the T-Nut by loosening or tightening it such that the small pin is flush with the bottom of the slot in the T-Nut on the bottom of the connector … This allows the top insulator to properly adjust and seat with the Atomizer providing smooth operation.  Pre-loading the spring with an over tightened T-Nut may result in ‘ratchety’ movement while installing an atomizer … Adjust the T-Nut prior to soldering!
Ring Terminals Are Included

 

 

Additional information

Qty

Single Unit, 3-Pack, 5-Pack, 10-Pack, 25-Pack

Reviews

There are no reviews yet.

Be the first to review “Varitube VT 510-V2 Connector”